'%ASA-3-210007: LU allocate xlate failed' messages on ASA 8.4(2) cluster

[ajtm]

I'm receiving a lot of these messages from the standby ASA since I upgrade the ASA cluster from 8.3(2). I see that I have some diferences in the xlat table. How can I get rid of these messages? Thanks.

[Julio Carvajal]

Hello Ajtm,

Are you getting the following log as well:

Failed to rep un_xlate for np/port/id/0/-1 10.64.33.120/3486 -  np/port/id/1/-1 10.207.1.35/22 flg: 101040 2100012

If yes, you are hitting bug ID:CSCts29271

If you want to disable those messages just do a:

-no logging message 210007

You will stop seeing those messages but the ASA will still to replicate connections to Standby.

Please rate helpful posts.

Regards,

Julio

[ajtm]

No, I'm not getting the "Failed to rep un_xlate for np/port/id/0/-1 1" messages.

Regards,

Antonio

[Julio Carvajal]

Hello Ajtm,

Are you seeing these messages on both units or just on one of them (witch one)?

Regards,

Julio

[ajtm]

Just the standby unit.

Regards,

António

[Julio Carvajal]

Hello Ajtm,

I think you are hitting this bug:

CSCts29271

HA ASA NAT: LU allocate xlate failed error - Failed to rep un_xlate

Symptom: ASA fails to replicate connections to Standby and generates the following errors:  %ASA-3-210007: LU allocate xlate failed

Conditions:

ASA 8.4 with Failover

The workaround for this would be downgrade, you can also try to upgrade to 8.4(2.3)

Please rate helpful posts.

Julio!!!!

[ajtm]

It's running asa842-k8!

Regards,

Antonio

[Julio Carvajal]

Hello Antonio,

On the bug information say this is a cosmetic bug, so in that case if you do not want to perform a downgrade you can stop logging this messages with the command:

-no logging message 210007

Please rate helpful posts,

Julio,

[ajtm]

Thanks for the advice.

Regards,

Antonio

[Julio Carvajal]

Hello Ajtm,

My pleasure, have a great day,

Julio