ASA 5506 Firepower - Factory defaults ?

[anders]

Is there a way to restore the factory settings for the ASA 5506 Firepower ?

I messed up the configuration and had to do a password recovery. So I followed this guide:

https://supportforums.cisco.com/document/79016/asa-password-recovery

But now it dosen't run there is no light in the Ethernet ports and I cannot get in contact with the web interface.

The mangement interface works fine.

Please help a newbee

Thanks

Anders

[Karsten Iwen · Accepted solution]

You are talking about the base ASA and not the FirePOWER module itself? Then:

ASA(config)# config factory-default