I used the ASDM start up wizard and CLI, but either way it will not allow changing of the IP address on the inside interfaces.
For the CLI, I entered:
ip address 192.168.2.1 255.255.255.0
All of the commands took fine except for the last one it did not even recognized "ip address" as a command while in interface configuration mode.
Also in the ASDM start up wizard, on the step where you select and interface and click the edit button, the edit button simply does not even respond and does not bring up the edit dialog page.
Any theories as to why the device is not even recognizing ip address as a command while in interface configuration mode, but it is recognizing other basic interface configuration mode commands such as security-level 100?
I'm using version 9.8(2), with device manager version 7.8(2) and firepower 2.2(2.52)
I was helping some friends and they were trying to solve a scalable VPN issues, specially these days with the pandemic situation.
I recommended to implement ASA VPN Load-Balancing.
This will allow to keep 1 FQDN for all RA-VPN users an...
Purpose of this article is to share our experience during that Covid-19 period where we were able to successfully setup a VPN configuration for remote worker using Alcatel 8068S phones with FTD 2110 running 18.104.22.168.I would like to thank all of my colleagu...
If you have ever configured central web authentication with ISE you understand that it requires one to configure ACL that dictates what traffic is to be redirected vs. let through without redirection. You also understand that this ACL needs to be config...
Cisco Defense Orchestrator (CDO) is a cloud-based multi-device manager that can manage security products like the Adaptive Security Appliance (ASA), the Firepower Threat Defense next-generation firewall, and Meraki devices, to name a few.&nb...