07-29-2021 04:58 PM
Hello,
I would like to know if someone has used the set connection command in a ASA 5506-X; are these commands supported in this ASA model ?
Best regards
set connection timeout {[ embryonic hh : mm : ss ][ idle hh : mm : ss [ reset ]][ half-closed hh : mm : ss ][ dcd [ retry_interval [ max_retries ]]]}
no set connection timeout {[ embryonic hh : mm : ss ][ idle hh : mm : ss ][ reset ][ half-closed hh : mm : ss ][ dcd [ retry_interval [ max_retries ]]]}
Solved! Go to Solution.
07-29-2021 06:45 PM
yes, they do, you can refer in command reference :
07-29-2021 06:45 PM
yes, they do, you can refer in command reference :
08-04-2021 10:12 AM - edited 08-04-2021 10:12 AM
Thanks, I was not sure until you brought me up to speed. I appreciate it
best regards,
08-05-2021 02:07 AM
hi,
i don't recommend tweaking those and usually they're left in default UNLESS there's an explicit use case/scenario needed to tweak them.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: