08-07-2013 06:32 AM - edited 03-11-2019 07:22 PM
I have an ASA 5510 using version 8.2(1) and I have enabled ssh, icmp and they work from the inside network but not from the outside network.
Further to this, I exposed one site from the inside interface on the ASA (192.168.1.100) to outside (1.1.1.7) using NAT and it is not pingable nor accessible from the outside. I also allowed SSH from the outside network to the external IP addresses of the ASA and it is not working either. Any ideas what I could be missing in my configuration? I bolded the configurations involved in the ASA running configuration I copied below (please note I have replaced the real IP addresses with 1.1.1.x and 2.2.2.x):
ASA Version 8.2(1)
!
hostname fw
domain-name net.com
enable password eYKAfQL1.ZSbcTXZ encrypted
passwd 2KFQnbNIdI.2KYOU encrypted
names
dns-guard
!
interface Ethernet0/0
description Primary Outside (Internet)
speed 10
duplex full
nameif outside
security-level 0
ip address 1.1.1.5 255.255.255.240
ospf cost 10
!
interface Ethernet0/1
description inside
speed 100
duplex full
nameif inside
security-level 100
ip address 192.168.1.254 255.255.255.0
ospf cost 10
!
interface Ethernet0/2
description WLAN
nameif WLAN
security-level 100
ip address 192.168.108.240 255.255.255.0
ospf cost 10
!
interface Ethernet0/3
description Secondary Outside (Internet)
speed 100
duplex full
nameif WAN2
security-level 0
ip address 2.2.2.133 255.255.255.192
!
interface Management0/0
description LAN/STATE Failover Interface
!
!
time-range after_hours
periodic weekdays 7:00 to 23:00
!
boot system disk0:/asa821-k8.bin
no ftp mode passive
clock timezone EST -5
clock summer-time EDT recurring
dns domain-lookup WLAN
dns server-group DefaultDNS
retries 3
timeout 5
name-server 8.8.8.8
name-server 206.191.0.210
name-server 4.2.2.1
name-server 4.2.2.2
domain-name net.com
access-list WAN2_access_in extended permit icmp any any echo-reply
access-list WAN2_access_in extended permit icmp any any time-exceeded
access-list WAN2_access_in extended permit icmp any any source-quench
access-list WAN2_access_in extended permit icmp any any unreachable
access-list WLAN_access_in extended permit icmp any any echo-reply
access-list WLAN_access_in extended permit icmp any any time-exceeded
access-list WLAN_access_in extended permit icmp any any source-quench
access-list WLAN_access_in extended permit icmp any any unreachable
access-list WLAN_access_in extended permit tcp host 192.168.1.100 eq ssh any
access-list WLAN_access_in extended permit tcp 192.168.1.0 255.255.255.0 host 192.168.1.100 eq ssh
access-list WLAN_access_in extended permit ip any any
access-list time_based extended permit ip any any time-range after_hours
access-list split_tunnel standard permit host 206.191.0.210
access-list split_tunnel standard permit host 206.191.0.140
access-list split_tunnel standard permit host 207.181.101.4
access-list split_tunnel standard permit host 207.181.101.5
access-list split_tunnel standard permit 192.168.1.0 255.255.255.0
access-list outside_access_in extended permit icmp any any echo-reply
access-list outside_access_in extended permit icmp any any time-exceeded
access-list outside_access_in extended permit icmp any any
access-list outside_access_in extended permit tcp any host 1.1.1.7 eq ssh
access-list inside_access_in extended permit ip any any
access-list inside_access_in extended permit tcp any host 192.168.1.100 eq ssh
access-list inside_access_in extended permit icmp any any
access-list inside_access_in extended permit icmp 192.168.1.0 255.255.255.0 any
access-list inside_access_in extended permit ip 192.168.1.0 255.255.255.0 any
access-list inside_access_in extended permit tcp 192.168.1.0 255.255.255.0 host 192.168.1.100 eq ssh
pager lines 20
logging enable
logging asdm informational
mtu outside 1500
mtu inside 1500
mtu WLAN 1500
mtu WAN2 1500
ip local pool DHCP 192.168.1.245-192.168.1.252 mask 255.255.255.0
ip verify reverse-path interface outside
ip verify reverse-path interface WAN2
failover
failover lan unit secondary
failover lan interface FO Management0/0
failover key *****
failover link FO Management0/0
failover interface ip FO 192.168.255.171 255.255.255.0 standby 192.168.255.172
icmp unreachable rate-limit 1 burst-size 1
icmp permit any outside
icmp permit any inside
icmp permit any WLAN
icmp permit any WAN2
asdm image disk0:/asdm-621.bin
asdm history enable
arp timeout 14400
global (outside) 1 interface
global (WAN2) 1 interface
nat (inside) 1 192.168.1.0 255.255.255.0
nat (WLAN) 1 192.168.108.0 255.255.255.0
static (inside,outside) 1.1.1.7 192.168.1.100 netmask 255.255.255.255
access-group outside_access_in in interface outside
access-group inside_access_in in interface inside
access-group WLAN_access_in in interface WLAN
access-group WAN2_access_in in interface WAN2
route outside 0.0.0.0 0.0.0.0 1.1.1.1 1
route WAN2 0.0.0.0 0.0.0.0 2.2.2.129 254
route inside 192.168.1.100 255.255.255.255 192.168.1.0 1
timeout xlate 3:00:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout sip-provisional-media 0:02:00 uauth 0:05:00 absolute
timeout tcp-proxy-reassembly 0:01:00
dynamic-access-policy-record DfltAccessPolicy
aaa authentication ssh console LOCAL
http server enable
http 192.168.108.0 255.255.255.0 WLAN
http 192.168.1.0 255.255.255.0 inside
http 192.168.1.101 255.255.255.255 inside
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart
sla monitor 123
type echo protocol ipIcmpEcho 4.2.2.2 interface outside
num-packets 3
timeout 1000
frequency 3
service resetoutside
crypto ipsec transform-set ESP-3DES-SHA esp-3des esp-sha-hmac
crypto ipsec transform-set ESP-AES-128-SHA esp-aes esp-sha-hmac
crypto ipsec transform-set ESP-AES-256-MD5 esp-aes-256 esp-md5-hmac
crypto ipsec transform-set ESP-DES-MD5 esp-des esp-md5-hmac
crypto ipsec transform-set ESP-AES-256-SHA esp-aes-256 esp-sha-hmac
crypto ipsec transform-set ESP-AES-128-MD5 esp-aes esp-md5-hmac
crypto ipsec transform-set ESP-DES-SHA esp-des esp-sha-hmac
crypto ipsec transform-set ESP-AES-192-MD5 esp-aes-192 esp-md5-hmac
crypto ipsec transform-set ESP-AES-192-SHA esp-aes-192 esp-sha-hmac
crypto ipsec transform-set ESP-3DES-MD5 esp-3des esp-md5-hmac
crypto ipsec security-association lifetime seconds 28800
crypto ipsec security-association lifetime kilobytes 4608000
crypto dynamic-map SYSTEM_DEFAULT_CRYPTO_MAP 65535 set pfs group1
crypto dynamic-map SYSTEM_DEFAULT_CRYPTO_MAP 65535 set transform-set ESP-AES-128-SHA ESP-AES-128-MD5 ESP-AES-192-SHA ESP-AES-192-MD5 ESP-AES-256-SHA ESP-AES-256-MD5 ESP-3DES-SHA ESP-3DES-MD5 ESP-DES-SHA ESP-DES-MD5
crypto map outside_map 65535 ipsec-isakmp dynamic SYSTEM_DEFAULT_CRYPTO_MAP
crypto map outside_map interface outside
crypto isakmp enable outside
crypto isakmp policy 10
authentication pre-share
encryption 3des
hash sha
group 2
lifetime 86400
!
track 1 rtr 123 reachability
no vpn-addr-assign aaa
no vpn-addr-assign dhcp
telnet timeout 5
ssh scopy enable
ssh 2.2.2.132 255.255.255.255 outside
ssh 69.17.141.134 255.255.255.255 outside
ssh 192.168.1.0 255.255.255.0 inside
ssh 192.168.1.100 255.255.255.255 inside
ssh 192.168.108.0 255.255.255.0 WLAN
ssh timeout 60
console timeout 0
management-access inside
dhcpd address 192.168.108.11-192.168.108.239 WLAN
!
threat-detection basic-threat
threat-detection statistics access-list
no threat-detection statistics tcp-intercept
ntp authenticate
ntp server 128.100.100.128
ntp server 132.246.168.148
ntp server 128.100.56.135
tftp-server inside 192.168.1.100 /
webvpn
group-policy Wifi internal
group-policy Wifi attributes
wins-server none
dns-server value 206.191.0.210 206.191.0.140
vpn-tunnel-protocol IPSec l2tp-ipsec svc webvpn
split-tunnel-policy tunnelspecified
split-tunnel-network-list value split_tunnel
tunnel-group Wifi type remote-access
tunnel-group Wifi general-attributes
address-pool DHCP
default-group-policy Wifi
tunnel-group Wifi ipsec-attributes
pre-shared-key *
!
class-map inspection_default
match default-inspection-traffic
!
!
policy-map type inspect dns preset_dns_map
parameters
message-length maximum 512
policy-map global_policy
class inspection_default
inspect dns preset_dns_map
inspect ftp
inspect h323 h225
inspect h323 ras
inspect netbios
inspect rsh
inspect rtsp
inspect skinny
inspect esmtp
inspect sqlnet
inspect sunrpc
inspect tftp
inspect sip
inspect xdmcp
inspect icmp
inspect icmp error
policy-map type inspect dns migrated_dns_map_1
parameters
message-length maximum 512
!
service-policy global_policy global
prompt hostname context
Cryptochecksum:ac25ef0642e0ecb8f0ef63219833f3ae
: end
asdm image disk0:/asdm-621.bin
asdm location 192.168.1.245 255.255.255.255 inside
asdm location 192.168.1.252 255.255.255.255 inside
asdm history enable
08-07-2013 07:05 AM
Hi,
I can't see any problems right away in the configuration.
I guess we could start by using the "packet-tracer" to simulate the SSH and ICMP through the firewall
packet-tracer input outside tcp 1.1.1.1 12345
packet-tracer input outside icmp 1.1.1.1 8 0
Don'd mind the source address of 1.1.1.1. Its just an address that is located behind "outside" interface according to the ASA routing table. (As the configurations 1.1.1.0/28 is not actually configured on the ASA)
Share the exact "packet-tracer" command used (wihtout the public IP, notice that the output contains the public IP also) and the output of the command with us here.
Also, have you made sure that there is no old translations active on the ASA?
You can use this command to view those
show xlate local 192.168.1.100
You can clear the xlates with
clear xlate local 192.168.1.100
- Jouni
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide