I inherited a network redesign project mid implementation and ran across an issue that I was not 100% sure able to be resolved. Implementation is occurring in which the organization is changing over to a different ISP and we have some customers that will not be able to change their settings over to our new addresses from some time. I have seen a lot of posts about fail over and dual ISP configurations, but I could not relate them to this particular scenario.
ISP1 - Old
ISP2 - New
2x ASA 5520 - DMZ
ASA 5520s are on version 8.0 and running Active/Active
We have an FTP server in our DMZ and a secondary server in our Internal LAN that customers communicate with. The issue that I have been faced with is that some customers will be using ISP1 while others are using ISP2 until the full transition occurs. Since the customers have explicit firewall rules that only accept communication from a certain source address, we cannot send out the traffic just on ISP2 until they change their settings.
Any ideas or thoughts on how to configure to be able to make this happen?
Isn't this just a routing problem? Destination-old-customer gateway=old-ISP. That will cause traffic destined for a specific destination to be routed from the old ISP address. Static routes, not sexy, but work.
If you are going to use the old ISP just for the traffic comming from the old customer YES, you can set up a static route on the ASA and the ASA will do a route lookup every time he receives or send a packet to that particular host so it should not be a problem.
Please rate helpful posts.
Julio Carvajal Senior Network Security and Core Specialist CCIE #42930, 2xCCNP, JNCIP-SEC
Once you've expanded Cisco Secure Endpoint connector deployment to about 50% of your licensed count (check out this article that shows you how to do that), it's time to put those connectors to action i.e. convert them to Protect from Audit mode for vari...
Hello! I’m Betsy, UX Researcher, on the Cisco+ Secure Connect Now team. Nice to meet you all .We have a short survey to learn about your Zero Trust Network Access (ZTNA) journey. Whether you have, plan to, or have not implemented a ...
A set of interface access rules can cause the Cisco Adaptive Security Appliance to permit or deny a designated host to access another particular host with a specific network application (service). When there is only one client, one host and one se...
How To: Cisco ISE Captive Portals with Aruba Wireless
Authors: Adam Hollifield, Brad Johnson
IntroductionPrerequisitesMinimum RequirementsComponents UsedConfigurationAruba Wireless ControllerWLAN CreationAuthentication ConfigurationRole & Policy Confi...
Ready to learn more about SecureX? Our Cisco security expert @Juan Ponce Dominguez reviews the features and benefits of SecureX, as well as a product demo covering:
Customising SecureX dashboards to create a single pane, unified visibility