08-17-2011 10:40 PM - edited 03-11-2019 02:13 PM
Hi guys.
Need little help here with Failover, i have configured Failover Active/Standby and it was running few months but now its not working. and when i try to debug it its giving me these messages.
vpnfol_thread_timer: HA MSG: no Buffer available for clientvpnfo
these messages are on Active unit.
Any help with that....
Appreciate
thanks.
08-17-2011 11:29 PM
Hi Syed,
Can you tell me whats the exact issue?? Is the firewall crashing, and which firewall is crashing?? What debugs are you running??
-Varun
08-18-2011 12:02 AM
Hi Varun,
No issue. the issue is they are not syncing...the Failover is not working.. Currently the Primary firewall is active.. and standby is not acting as Ready for takeover. you know what imean.
Only the failover is not working.
i am running debug fover fail and getting these messages on primary one.
vpnfol_thread_timer: HA MSG: no Buffer available for clientvpnfo
08-18-2011 12:48 AM
Can you check on the secondary firewall whether you see any crashinfo on it, do "show crashinfo", it would also show you the date when it was collected.
-Varun
08-18-2011 12:52 AM
No crash info.
after checking it says.
No crash file found.
08-18-2011 01:00 AM
Hi Syed,
What is the ASA version that you are running, and could you share the config from your ASA??
-Varun
08-18-2011 02:42 AM
Thanks for your support Varun.
Sorry i cannot give you the whole config due to security reasons.. but i can paste the part which you want me to.. if thats fine with you?.
its ASA 5520 with ASA software version 8.2(4)
thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide