ASA 5525 Alarm

[eugene.hendrikse]

When i run command show controller pci. I get the below, How do i fix this.

 1.) System is not fully operational - The PCI device with vendor ID: 0x1000 (LSI) device ID: 0x0a05 (Accelerator) could not be found in the system.

[marce1000]

 - Connect to the ASA trough SSH with : https://cway.cisco.com/cli/  , at the top left , run or press System Diagnostics.

 M.

[eugene.hendrikse]

HI I have run the tool and only 1 critical. Software crash, we power cycled the device last night to see if that will resolve the issue.

[marce1000]

                                   >....HI I have run the tool and only 1 critical. Software crash

   - Note that in the CLI Analyzer you can also use the Crashinfo Analyzer  (at the right), also note that reply from Mr nagaslot is not relevant and will be reported as inappropriate content. This may result in this thread being removed completely. If so and your problems persists , you may want to post again.

 M.

[eugene.hendrikse]

HI did do the Traceback Analyzer and no crash detected

Cisco was unable to match your traceback to a known issue

[marce1000]

 - Ok , w.r.t to your original question you may find this thread informational too  : https://community.cisco.com/t5/network-security/cisco-asa-5525-x-alarm-led-on/td-p/2350012

 M.

[eugene.hendrikse]

Thank you, we did went through that post, the only option now is to log a TAC case. 

[marce1000]

  - Ok  , another option if crashes are observed is to look into the current software version running on the ASA , use an advisory release - if applicable , check if problems persist : https://software.cisco.com/download/home/284143129/type/280775065/release/9.14.3%20Interim

 M.