03-03-2013 12:47 PM - edited 03-11-2019 06:08 PM
Hello,
I have two Internet connections which are connected to two ISR 2951s. Also I have two ASAs 5545-Xs, which I want to use in Active/Active failover mode with multicontext. The question is: how can I configure ASAs to perform ISP load-balancing as well? Or it is not possible?
Thanks!
03-03-2013 01:23 PM
03-03-2013 01:26 PM
Also important to mention:
We can have the ASA working in multiple context and load balance on a per context basis.
Dynamic routing nor VPN [versions below 9.0] are supported.
03-03-2013 08:30 PM
Thank you jocamare! IS there any documentation on how to configure this in case of active/active failover?
03-03-2013 10:14 PM
I don't know of any official cisco file that will explain you this, but it's actually pretty simple.
One context can use one of the ISPs and the other will use the other ISP. That's about it, the rest is basic routing.
You might also like to check the following link, it describes the "cascading" concept
http://www.cisco.com/en/US/docs/security/asa/asa82/configuration/guide/contexts.html#wp1146927
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide