Hello All,
We have bought new Cisco ASA 5585X Firewalls.After configuration failover active/standby it began repeatedly to reload. Both ASAs keep reloading every hour at least 2-3 times.
The failover configuration is simple, just stateful failover.
failover
failover lan unit primary
failover lan interface failover GigabitEthernet0/3
failover polltime unit 10 holdtime 30
failover polltime interface 5 holdtime 40
failover key *****
failover link failover GigabitEthernet0/3
failover interface ip failover 10.10.130.1 255.255.255.0 standby 10.10.130.2
!
failover
failover lan unit secondary
failover lan interface failover GigabitEthernet0/3
failover polltime unit 10 holdtime 30
failover polltime interface 5 holdtime 40
failover key *****
failover link failover GigabitEthernet0/3
failover interface ip failover 10.10.130.1 255.255.255.0 standby 10.10.130.2
In standby mode, without failover they do not reload, the function normally. BUt when I enable failover, they begin to keep reload repeatedly.
Did you ever meet this problem? What could cause this problem?
It is first time I meet this
Best Regards
Tural Lachinov
