06-23-2011 11:54 AM - edited 03-11-2019 01:49 PM
I am trying to figure out how to create an etherchannel with sub-interfaces on an asa 5520 running 8.4.1 code. It doesn't seem to allow me to configure any type of sub interface on the port-channel or anywhere else once I create it. Does anyone know if this is supported, and if so, would you show an example config? I have been searching a while on this and can't seem to find out how. Thank you much!!
Solved! Go to Solution.
06-23-2011 12:04 PM
Hi Corey,
Do you see any specific error message? Here is a doc on how to configure a subint on etherchannel:
Hope this helps!
Regards,
Anu
P.S. Please mark the question as answered if it has been resolved. Do rate helpful posts!
06-23-2011 12:04 PM
Hi Corey,
Do you see any specific error message? Here is a doc on how to configure a subint on etherchannel:
Hope this helps!
Regards,
Anu
P.S. Please mark the question as answered if it has been resolved. Do rate helpful posts!
06-23-2011 12:11 PM
I haven't seen this exact document. I will try this and let you know what I find out. Thanks Anu!
06-23-2011 03:35 PM
You cannot create etherchannel from sub-interfaces however you can create sub-interfaces of etherchannel interface as this essentially becomes a single bundle port so creating a sub-interface on physical or etherchannel interface is same.
06-25-2011 07:32 AM
Ok so I figured it out. You have to apply the "channel-group
02-22-2016 10:33 AM
Is this etherchannel sub-interface have a layer 3 config on it..or is it strictly layer 2 with the vlan id.
Can you post your config
I am trying do something similar. Thanks
I want to create L3 port-channels sub-interfaces with vlan id.
On older models 5505s, you can L3 SVI, with the interfaces have L2 switchport access
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide