ASA 8.4 NAT static and dynamic with the same public IP

[r.spiandorello]

Hi, in ASA 8.4, I need to use to static nat an internal IP with a public IP and use the same public IP to dynamic nat another internal IP:

nat (inside,outside) source static IP1_PRIVATE IP_PUBLIC

nat (inside,outside) source dynamic IP2_PRIVATE IP_PUBLIC

All outgoing connection from IP1_PRIVATE and IP2_PRIVATE should be natted to IP_PUBLIC and all incoming connection to IP_PUBLIC should be forwarded to IP1_PRIVATE: is it correct ?

thank you in advance

greatings

rs

[Julio Carvajal]

Hello,

As soon as the inbound connection is using a different port from the connections created for the outbound connection that should work.

Regards,

Julio

[r.spiandorello]

it's necessary to migrate from a check point solution that allows that.

thanks

Sent from Cisco Technical Support iPhone App

[Julio Carvajal]

Hello ,

It is completeley difficult that an outbound and inbound connection trough the ASA share the same port because remember that connections innitiaded on your inside host will use a random port so do not worry for that.

Please rate helpful post.

Have a great day,

Julio