asa in eveng is not showing any interfaces

[Neaz_Arefin]

hi, when ever I'm using cisco asa in eveng NOT the ASAV, most of the time the asa it is not showing any interfaces but once in a while is shows interfaces, anybody has any idea of remedy it ? Thank you. 

[balaji.bandi]

what version of ASA  - never seen this issue on my labs

follow below guide :

https://www.youtube.com/watch?v=atFzZrf9xfk

[Neaz_Arefin]

Sometime it shows interfaces, most of the time it doesn't. I know it's strange !! in a lab if I'm using multiple ASAs of the same model, os, hardware version one is showing all the interfaces Vs other doesn't. so the whole time and effort for he lab goes in vain. 
Problem :-
asa-1(config)# sh int ip br
Interface              IP-Address                OK?   Method Status Protocol
 IT IS NOT SHOWING ANY INTERFACES HERE  
      
    
asa-1(config)# sh run 
ASA Version 9.1(5)16
: Serial Number: JMX1203L0NN
: Hardware: ASA5520, 3072 MB RAM, CPU Pentium II 1000 MHz

asa-1(config)# sh ver

Cisco Adaptive Security Appliance Software Version 9.1(5)16
Device Manager Version 7.3(3)

any solution ? I need to use the ASA in EVE-NG for few labs not the asaV though. Tried couple of other versions of the asa,
however haven't got any solution yet.  

[balaji.bandi]

I used the same version and it works as expected.

here is my template config :

[zouextzouaext37622]

Hello, 

You have to change the interface mode 

[Villager]

Just create and new lab and I'm working on that.