03-17-2024 05:16 AM
Hello Guy,
Do anyone know how to check the existing the config-register on the ASA firewall please.
when one of my HA firewalls reboots it goes to ROMON mode and I have to manually do boot to boot it up.
How can i solve this issue please?
I'm using ASA built in firepower 2K
Best Regards,
SS
Solved! Go to Solution.
03-17-2024 08:54 AM
Use "confreg 0x1" to set the value and then "reboot" from the ROMMON mode. Also, "confreg" from the ROMMON mode can be used to check the config-register value.
03-19-2024 08:10 AM
if you can access via console from
firepower> show version system
this give you the register you now use
MHM
03-17-2024 05:48 AM
firepower # scope system
firepower /system # show firmware detail
try this, see if you get useful info about the FPR
MHM
03-19-2024 04:37 AM
Hello MHM,
It didn't work. I was wondering if we could check it on ASA like we do it on cisco router when we do show version
03-19-2024 08:10 AM
if you can access via console from
firepower> show version system
this give you the register you now use
MHM
03-17-2024 08:54 AM
Use "confreg 0x1" to set the value and then "reboot" from the ROMMON mode. Also, "confreg" from the ROMMON mode can be used to check the config-register value.
03-19-2024 04:39 AM
Hello Tvvona,
I did that and it solved a problem, but i wanted to check the existing configreg before i make any changes. because the fiirepower box was bran new it was not used in productions before.
03-19-2024 08:50 AM
"confreg" alone should print the value and then allow you to modify it.
03-23-2024 05:28 AM
Thank you, guys, for the info i have managed to solve the issues with your help.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide