07-15-2022 06:53 PM
Dear Team,
As per attached topology attached, i would like to map ASA port eth 0 and eth 1 in INSIDE interface ?
How shall i achieve this design ? Is it possible ?
regards
Virendra p
07-15-2022 08:17 PM
https://www.petenetlive.com/KB/Article/0001422
Use bvi as example above
07-16-2022 12:37 AM
Are you looking to separate the network, what is the goal here as Firewall -
if " i would like to map ASA port eth 0 and eth 1 in INSIDE interface ? "
If you looking DC firewall to be transparent mode - may be worth looking below example (this is my just guess what you trying to achieve)
07-16-2022 09:27 AM
Why would you want to do that? I think the only option to do it would be to create a bridge interface and place eth0 and eth1 in that bridge group, but that means both interfaces will need to be on the same subnet.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide