ASA Route map with prefix list, strange characters

[BCHC_TechnicalServices]

Hi all I'm getting a some funny characters after i issues a command to apply a 'match ip address' command, im connected via SSH. I have tried using putty and tera term.

These show up when you issue SHOW RUN, they are preventing the config from being fully written to start-up, as it hits these characters and stops.

See below in bold

ASA5525X

Version 8.6(1)2

Any ideas?

route-map ALLOW_SUBNETS_REDIST permit 10

match ip address prefix-list PREFIX_1 ÿÿÿÿ

prefix-list PREFIX_1 seq 5 permit x.x.x.x/8

prefix-list PREFIX_1 seq 6 permit x.x.x.x/23

prefix-list PREFIX_1 seq 7 permit x.x.x.x/23

prefix-list PREFIX_1 seq 8 permit x.x.x.x/24

prefix-list PREFIX_1 seq 9 permit x.x.x.x/24

Thanks

[BCHC_TechnicalServices]

I guess nobody has been this before then lol

[ryan.coakley93]

I have had some issues with putty sending strange charecters, but never with any Cisco device. I have never found a fix..