Network Security

Hi,i have ASA multicontext and transparent in Active/Standby mode, failover is OK, i dont have managment ip address the firewall is managed by ip address assigned on inside context.config.:inside context (admin context)ip address 10.1.1.1 255.255.255...

If I configure an ASA, let's say the g0/1 port with a static ip address of 192.168.1.1 and assign it to the inside network, make g0/0 my outside connection, my question is if I have 2 workstations which will have a static ip address on the 192.168.1....

hi all,can i copy running-config to another file in the flash, do testing on it, if something goes wrong, put it back.  like...asa>copy running-config my-configtesting...revert...asa>copy my-config running-configasa>reloadis it like that?thanks!

                   We are deploying AP's with 802.1x ports. We do not want ot have static AP ports. When plugged into a switch port with 802.1x configured the AP does not kick up the smart port trigger. How do I link the trigger from ISE to send the ...

I only have this particular context monitoring in this case, but if it was set to drop blacklisted packets it would be dropping all of our DNS traffic from our campus DNS servers to *.akadns.org, which seems to be an Akamai DNS infrastructure.FYI. I ...

         Could I get a validation that this config is correct in that it allows inbound access to the web serverand that I should be able to ping it from my inside interface. I tried to use the example code from Cisco DocID: 115904 for DMZ WebServer,...

Hi all  I am using a FWSM firewall  and have set up a Dynamic  policy  to PAT   a  /8  network  into a /30  network... Problem I see is that the PAT is only using the first address in the pool for mulitple connections ,  I need it to use all 4 availa...

HIAS checked on asa we are geeting the above logs.Cpu on asa is almost 99 utilization .Interseting thing is no user traffic is effected everything is running as usual.Why question is eventhough cpu is high no traffic being affected.More ever we are n...

HI,when i start the IME , it takes around 10 minutes to open so is this normal?your support is highly appricated.

Hi allI'm using Asa 902, and I deploy any connect ssl only and no IPSec... It always open only connection if you start via browser, you cannot reconnect using installed software.Is it really like that?Sent from Cisco Technical Support iPhone App

below is my config.  Can someone tell if this below config will let my users .36.0/24 access the internet? i think it does but i need to be certain. the 192.168.36.0/24 just needs all outbound access for internet and any thing outbound?: Saved:ASA Ve...