ASA Secondary active

[hienhaidam]

Hi ,

I've a pair of ASA 5540 used as firewalls. Recently the Secondary unit becomes ACTIVE for unknown reasons. So I apply the CLI "no failover active" to make the Primary active. But a little later, the Secondary appears again active. I did it several times and the issue is still there. Do you guys have met this issue ?

System image file is "disk0:/asa832-k8.bin"

Hardware:   ASA5540, 2048 MB RAM, CPU Pentium 4 2000 MHz

Internal ATA Compact Flash, 256MB

BIOS Flash M50FW080 @ 0xfff00000, 1024KB

Regards,

hh

[ajay chauhan]

Failover will happen for some reason you should check firewall logs carefully also status of interfaces on active device.