Network Security

Hi.I'm expreiencing a problem in the FWSM on the company. The virtual context stops doing NATs suddenly and the servers behind it get no access to anything.The firewall has several static policy nats with port forwarding configured on the Inside inte...

Hi All,We have been trying to get MS Lync working through our proxy server, but for some reason we cannot get this working.Even through Lync has IE proxy configuration settings for all external traffic to route through the proxy server, my syslog sho...

Does anybody know if PBR is available in either 8.2 or 8.4 and if so are there hardware requirements?

I have Cisco ASA5510 which is causing issue. when i download somthing through firewall download speed decreases and if i bypass the firewall (directly connecting to router through static IP) i am getting proper download speed.i have set the port on a...

Dear All,I have got new cisco ASA 5580 running 7.2(4) on it  when i am trying to configured Virtual interface on vlan 400 in  Gi0/0.400 to LBASE.now the problem is from my MZ zone 10.242.107.17 to Lbase virtual interface 10.242.103.1 iam not able to ...

This is my pix configurationglobal (outside) 1 interfaceglobal (inside) 1 interfacenat (inside) 1 access-list 100 0 0nat (inside) 1 10.0.1.7 255.255.255.255 0 0nat (inside) 1 10.0.1.8 255.255.255.255 0 0static (inside,outside) 203.129.203.165 10.0.1....

    Hi All,I have a Cisco ASA Firewall where it have three legs named as inside, dmz and outside with the security levels 100,50 & 0 respectively.i have the below configuration :nat (inside) 75 access-list outnatnat (inside) 25 access-list dmznatglob...

  HI I have two Cisco ASA 5540, these ASA running ver 7.2. and used mainly as VPN gateways.My question is simple, Apart from the extra AnyConnect client functionality and the higher encryption, is there any specific security benefits (related to the ...

Is it possivble to have 10 security licenses, license to a Cisco 5510 and have them transfeered to a Cisco5520?    

Hi,Is it possible to upgrade directly from 8.0(4) to 8.2(5) software in 5510. Is there be any workaround in regards to the config. Thanks,

Currently I have an asa 5510 set up with one block of outside IP addresses. Everything is working fine in regards to my initial setup. However we needed to purchase additional IPs from our provider and ended up being a whole complete different block....