06-14-2023 01:25 AM
In the ASA failover setup, primary>Active firewall the show module shows the SFR status. as init state not UP state.
I got the same result. after reload the SFR module #sw-module module sfr reload.
#show module
unable to read details from module sfr
status; Init
Solved! Go to Solution.
06-14-2023 05:59 AM
06-14-2023 02:30 AM
Init state generally indicates that the sfr module is not fully installed. We see this most commonly when the boot image (img file) has been installed but the system image has not been (sys file). Check the sfr module console output for details.
06-14-2023 02:57 AM
06-14-2023 05:59 AM
06-14-2023 03:50 AM
Marvin,
The Sfr module in the standby firewall is UP and running. Shall I failover it to the active state and then re-image the firewall that is the standby FW?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide