"Deployment failed due to another deployment in progress for this device. Retry deployment," is the error. I have rebooted firepower manager system but it is still stuck in deployment. How do I kill the processors for deployment. Had to re-image S...
Hi. I'm trying to establish if I have my firewall setup correctly for stateful failover. We've had reports that failing over the firewalls caused ip phones to drop their calls, suggesting it is not setup as stateful. From what I can establish, it is ...
We can use Amazon S3 ESC Storage instead of instead of SFTP Cisco ISE 3.1 Patch 8
Hi Guys, I have a Cisco 1010 FTD using FW version 7.2.4 and I have 2 ISPs. One is a leased line but the other is a FTTC so that uses a PPPoE username, password with 1 singular external IP address. I have found the solution of an SLA monitor the defau...
Hi,I have a Cisco FTD 1150, looking to install a new ISP fiber connection. Currently, I have port 1/9 enabled, however, when I plug in the second SFP module to any of the other SFP ports (1/10-1/12), the 1/9 port gets disconnected along with the new ...
Hi,After upgrading our FPR-2110 running as ASA version 9.12 (4) to 9.18.4.22 , an object group and access list disappeared upon reload.We re-added them , however once again after issuing write memory and reloading the ASA again after a few days, the ...
Hi,My team is facing with this issue after upgrade from 7.2.5 into 7.2.7 and snort version 3.Anyone have any similar issue same with my team?
Hi all,I have an old Cisco PIX (I know, out of support, replacing later this year) - and was wondering if anyone would know why when I type in the option "show conn", some connections come back with no flags?TCP out xxx.xxx.xxx.xxx:443 in xxx.xxx.xxx...
Ok; here’s what I’m wondering… I have as mentioned in title an ASA5506W-X and management(1/1) ran to the inside(1/2) interface. I know I have the settings right but bc I don’t have another switch to use in order to connect to the ASDM to see that it’...
Hi there,We have FMC with a 1010 FTD, I'm looking to be able to apply web restrictions such as safesearch and social media to specific users however we don't have AD is it possible?A little context, this is for a public library, we have an adults and...
Hello Guys. Iam a newbie from Vietnam, my company has a HA pair of ASA55345, and i have a problem that 1 of 2 ASA has rebooting randomly everyday and i dont know the reason why. Last month it rebooting randomly once a month and now it rebooting rando...
Hi,Wrote my first document on the Firewall / Documents section here at CSC.It has some basic information about the new NAT format and its operation.I am planning on later updating it and adding additional information and ofcourse correct possible mis...
how to add local GUI user in FTD using FDM with admin privilege
Hello everyone, We have a new firewall cluster (active-passive) in our company, consisting of 2x Firepower 1010. A few days ago, the cluster failed for unknown reasons and did not recover on its own. Only a restart was able to resolve the problem. We...
Hi GuysSo we have an already working Site to Site VPN on our FTD, I have ran into an issue with the FTD I have added a couple of IP Addresses in the config and added an ACL allowing RDP and also used the same NAT rule as the working IPs, when I run...
