ASA version 8.2.x Transparent firewall I would like create ip address on interface management, inside and outside ?

[Suparat Juldumnerntum]

I have some question

ASA version 8.2.x Firewall transparent mode

I would like create ip address on interface management, inside and outside ?

management ip address 10.1.1.10/24
inside ip address 10.1.1.11/24
outside ip address 10.1.1.12/24

R1----ASA----R2

R1#
interface fa0/0 
ip address 10.1.1.1 255.255.255.0 

R2# 
interface fa0/0
ip address 10.1.1.2 255.255.255.0 

I can create interface management, inside and outside on Cisco ASA ? 
example configuration 

ASA(config)# ip address 10.1.1.10 255.255.255.0

ASA(config)# interface gi0/0
ASA(config-if)# nameif inside 
ASA(config-if)# security-level 100
ASA(config-if)# ip address 10.1.1.11 255.255.255.0

ASA(config)# interface gi0/1
ASA(config-if)# nameif outside 
ASA(config-if)# security-level 0
ASA(config-if)# ip address 10.1.1.12 255.255.255.0

please recommend 

[Marius Gunnerud · Accepted solution]

To do that you would need to configure the ASA in routed mode, not transparent.  In transparent mode the physical interfaces are associated with a BVI interface which will have the IP address and be used for management.

So if you have to have IPs on the interfaces themselves, then you need to change the mode to routed

--

Please remember to select a correct answer and rate helpful posts