10-25-2014 11:49 AM - edited 03-11-2019 09:59 PM
I have some question
ASA version 8.2.x Firewall transparent mode
I would like create ip address on interface management, inside and outside ?
management ip address 10.1.1.10/24
inside ip address 10.1.1.11/24
outside ip address 10.1.1.12/24
R1----ASA----R2
R1#
interface fa0/0
ip address 10.1.1.1 255.255.255.0
R2#
interface fa0/0
ip address 10.1.1.2 255.255.255.0
I can create interface management, inside and outside on Cisco ASA ?
example configuration
ASA(config)# ip address 10.1.1.10 255.255.255.0
ASA(config)# interface gi0/0
ASA(config-if)# nameif inside
ASA(config-if)# security-level 100
ASA(config-if)# ip address 10.1.1.11 255.255.255.0
ASA(config)# interface gi0/1
ASA(config-if)# nameif outside
ASA(config-if)# security-level 0
ASA(config-if)# ip address 10.1.1.12 255.255.255.0
please recommend
Solved! Go to Solution.
10-25-2014 12:25 PM
To do that you would need to configure the ASA in routed mode, not transparent. In transparent mode the physical interfaces are associated with a BVI interface which will have the IP address and be used for management.
So if you have to have IPs on the interfaces themselves, then you need to change the mode to routed
--
Please remember to select a correct answer and rate helpful posts
10-25-2014 12:25 PM
To do that you would need to configure the ASA in routed mode, not transparent. In transparent mode the physical interfaces are associated with a BVI interface which will have the IP address and be used for management.
So if you have to have IPs on the interfaces themselves, then you need to change the mode to routed
--
Please remember to select a correct answer and rate helpful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide