ASA5506-X dual wan interfaces routing

[riccardodem]

Hi all, with network topology descrived in this topic:

https://community.cisco.com/t5/firewalls/asa5506-x-enable-comunication-between-vlans-and-remote-managment/m-p/3391711

2x isp routers for internet access with dhcp on lan interfaces and 2 different subnets

1x asa 5506-x

2x L2 switches on lan side

i have 2 giga interfaces of the ASA configured with this comand:

ip address dhcp setroute 

and nat set to balance diffent vlan traffic to different outside interfaces:

nat (vlan1,outside) source dynamic any interface
nat (vlan2,outside2) source dynamic any interface

is this configuration correct or is it preferable to use static routes? if I do a "show route" I only see default route to outside2 interface:

S*       0.0.0.0 0.0.0.0 [1/0] via 192.168.2.1, outside2

thanks

R.

[balaji.bandi]

As per your description, is the VLAN2 users working ? they able to get on to internet,

If yes, then add another static router same like outside2  replace with vlan 1 IP and outside

or post the full configuration to review and suggest.

[riccardodem]

attached the current conf. 

GigabitEthernet1/1 to isp modem 1

GigabitEthernet1/2 to isp modem 2

vlan 101 need to get on to internet by GigabitEthernet1/1 (outside 1)

vlan 102 need to get on to internet by GigabitEthernet1/2 (outside 2)

thank you

[riccardodem]

Policy based routing can be the solution?