ASA5510 NAT configuration question

[David Hunt]

Hello friends...

I have 30 IP cameras with a private IP address:

10.1.1.1 – 10.1.1.30

I have a Cisco ASA 5510 firewall.

I want to be able to use one public IP address, example, 50.50.50.50

With a specific port to go to a different internal camera,

Example

50.50.50.50:3001 should be NATTED to camera 10.1.1.1

50.50.50.50:3002 should be NATTED to camera 10.1.1.2

50.50.50.50:3003 should be NATTED to camera 10.1.1.3

50.50.50.50:3004 should be NATTED to camera 10.1.1.4

Etc…

How do I do this? I know how to create NAT… just not like this, please help!!

Any help is greatly appreciated.

Thanks

David

[Dan-Ciprian Cicioiu]

Hi David ,

What software version are you running ?

What port is used on the camera ?

Dan

[David Hunt]

ASA is 6.3

each internal IP camera is view over http:, so i am guessing 10.1.1.1:80

[Dan-Ciprian Cicioiu]

I do not think that the softward version of the ASA is 6.3 , this is an older version that was on PIX.

Isn't it this the ASDM version ?

Dan

[David Hunt]

hi...

sorry...

Cisco Adaptive Security Appliance Software Version 8.2(4)

Device Manager Version 6.3(5) Cisco Adaptive Security Appliance Software Version 8.2(4)
Device Manager Version 6.3(5)

[Dan-Ciprian Cicioiu · Accepted solution]

Hi,

No worries.

static (inside,outside) tcp 50.50.50.50 3001 10.1.1.1 80

static (inside,outside) tcp 50.50.50.50 3002 10.1.1.2 80

static (inside,outside) tcp 50.50.50.50 3003 10.1.1.3 80

static (inside,outside) tcp 50.50.50.50 3004 10.1.1.4 80

static (inside,outside) tcp 50.50.50.50 3005 10.1.1.5 80

Dan