Good afternoon friends,
We are a non for profit agency and albeit the setup is about 10 years old, we were gifted all of the network hardware from a company in downtown Chicago.
In the one rack, there are 2 Cisco Nexus 5548P switches installed at...
Hello friends,
I am trying to establish a 10 GB fiber connection between two Cisco switches.
Switch 1 - Cisco WS-C3650-48PQ has 4 x 10 Gigabit Ethernet with SFP+ uplinks
Switch 2 - Cisco WS-C2960X-48FPD-L has 2 x 10 Gigibit Ethernet with SFP+ upl...
I have a distance of 700 meters, semi clear line of site.
I have 2 Cisco AP1532E access points (http://www.cisco.com/c/en/us/support/wireless/aironet-1530e-outdoor-acce...)
is their an antenna that I can use to create a wireless bridge?
tryin...
Hello friends,Brief explanation - If you look at the attached pdf, superimposed over the top of our switch network you will see our Wi-Fi network all in red. In the bottom left hand corner in the location called Oakton you will see a red access point...
Hello friendsIn the diagram below, I am in the process of deploying the switch with the IP of 192.168.100.14.As you can see, the difference between this switch and the others is that it daisy chains off of 192.168.100.15 and is not part of the hub\sp...
Thank you, if you do not mind, can we please delve deeper into data center design?
I found this article on top of rack vs end of row data center designs .
This article thoroughly described the various data center rack designs.
If there is a lear...
I thought about that but with no light received indicates to me no connection at all. The only time I get a connection or "light" is when using the 1000BaseSX SFP. When I insert the SFP-10GBase-SR GBIC and swap patch cables, I do not receive any lig...