01-26-2017 10:50 AM - edited 03-12-2019 06:16 AM
I know the SFR module was working because I originally set it up a year ago. Module is fine on the Primary ASA.
SFR module was working fine on the secondary of the HA pair but noticed this:
Cisco Adaptive Security Appliance Software Version 9.6(2)
Device Manager Version 7.6(2)150
HQ-ASA5525/sec/stby# show inventory
Name: "Chassis", DESCR: "ASA 5525-X with SW, 8 GE Data, 1 GE Mgmt, AC"
PID: ASA5525 , VID: V03 , SN: XXXXXXXXX
Module not listed......
Shutdown unit - reseated SSD
Connected console and watched boot process- no notable errors to report
Green light is lit for HDD
Same result as above
debug module-boot 255
sw-module module sfr reset
show module
Mod status shows
sfr - init
after a while
show module
Mod status shows
sfr - Unresponsive
Is the SSD bad?
Solved! Go to Solution.
01-28-2017 07:56 PM
I'd lean towards the SSD being faulty. It should show up in hardware inventory no matter the sfr software module status.
01-27-2017 12:00 AM
Not necessary. I believe the module is screwed up. Try to reinstall it, first.
01-28-2017 07:56 PM
I'd lean towards the SSD being faulty. It should show up in hardware inventory no matter the sfr software module status.
01-29-2017 05:40 AM
If you suspect a bad component, open a TAC case. You can get a SSD replacement, if it's faulty. (if covered by your support).
01-29-2017 07:31 PM
I am leaning the same way but was hoping someone had something other than show inventory to TS the hardware. As soon as I get time to open a TAC case I will let you know for sure.
03-23-2017 09:47 PM
Replaced the SSD and it showed up. Still cant figure out what happened. Unit is back up and running.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide