Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This is also happening in the latest release as well. We have a pair of FP2110s in appliance mode and running multiple contexts in HA and seeing emails from both serial numbers.Cisco Adaptive Security Appliance Software Version 9.14(2)13 <context>SS...
I was checking a site to site VPN and noticed the attached. The ASA is configured as below so I am not sure why I am seeing 28800 Rekey Time Interval for only one of the allowed IPs in the interesting traffic. Can someone please explain? Full disc...
UCCX
System version: 10.0.1.10000-56
Keep getting the error about characters not allowed when uploading a .wav or .zip file
"Special characters like &, %, :, *, ?, ", <, >, |, ' are not allowed in File Name. Please try again"
I have tried Firefox v...
Which is the best way to configure the ASA for the following desired output:
We will have 2 3850 switches in a stack running multiple VRFs which will use the ASA as their gateway. We do not want to send a single link to the INSIDE interface. That ma...
Cisco IOS Software, C2960X Software (C2960X-UNIVERSALK9-M), Version 15.2(2)E3, RELEASE SOFTWARE (fc3)
Trying to accomplish the following on a 2960XR
Takes this command:
track 10 ip sla 11 reachability
ip route 10.200.250.0 255.255.255.0 10.1.10.1 tra...
Thanks for the response. I was hoping it was some hidden rule that I was unaware of. So I am guessing this will go unanswered because I cannot see the distant end config and right now your theory is the interesting traffic is different. I was the...
So they provided Beta 1.4.9.4... Should be out for general release sometime this fall. This was supposedly done to specifically address the above issue in the version. I have not had the issue since the update. Its been close to a month now.
Same issue... When I had the problem before they had me update to 1.4.8.6. Here we are again. Same issue. Anyhow going to call and see if they have an update. Really, this should be fixed by now in a general release I can grab instead of having t...
