ASDM image file is not set

[jennifer032415]

I've been trying to configure this Cisco ASA 5510 Firewall using ASDM, but it won't let me configure it, and when I try to show asdm image, it says Device Manager image file is not set.

[Rob Ingram]

@jennifer032415 from the CLI run

asdm image disk0:/asdm-761.bin

https://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/200142-ASA-9-x-Upgrade-a-Software-Image-using.html

[jennifer032415]

For this solution you recomment me that through TFTP server copy an ASDM image upgrade? 

[Rob Ingram]

@jennifer032415 well from your screenshot above you already have the ASDM image on the device, you just need to configure the asdm image as per the configuration I provided above. So no need to copy the image from TFTP.

[jennifer032415]

Well, I already configured it, when in my Google browser I write my ip that I configured in the interface and I connect with an ethernet cable, it does not respond. In the CMD if I reach that ip.

[balaji.bandi]

what the ASA version and compatability matrix of asdm and do the config as below :

https://www.cisco.com/c/en/us/td/docs/security/asa/compatibility/asamatrx.html

config t

asdm image disk0:/asdm-xxxxxx.bin

!

end

check show asdm image

make sure you enable http to access gui

[jennifer032415]

This is software ASA version, so what I can choose?