12-18-2016 07:05 PM - edited 03-12-2019 01:40 AM
Hi Support,
We are having two units of ASA5550 configured one for Active and one Standby respectively.
Issue: We able to launch the Active unit BUT NOT the Standby unit.
Running version
ASA Version 8.2(5)51
boot system disk0:/asa825-51-k8.bin
boot system disk0:/asa822-k8.bin
asdm image disk0:/asdm-645-206.bin
Attached the Java log for your assistance.
Thanks & Regards,
Chua
Solved! Go to Solution.
12-19-2016 07:07 PM
Do you have one of the ASA's in the Java exception list by any chance? Also, could you try launching the ASDM from the browser using the URL https://x.x.x.x/admin to see if the behavior is different. Ideally both should have the same behavior since the config is replicated on both firewalls. You might also want to check if the ASDM image on the ASA flash is the same on both Firewalls (this is not replicated).
I would recommend using the latest 7.x ASDM release as this is backward compatible with the 8.2(5) release of the ASA also.
http://www.cisco.com/c/en/us/td/docs/security/asdm/7_6/release/notes/rn76.html
12-19-2016 07:07 PM
Do you have one of the ASA's in the Java exception list by any chance? Also, could you try launching the ASDM from the browser using the URL https://x.x.x.x/admin to see if the behavior is different. Ideally both should have the same behavior since the config is replicated on both firewalls. You might also want to check if the ASDM image on the ASA flash is the same on both Firewalls (this is not replicated).
I would recommend using the latest 7.x ASDM release as this is backward compatible with the 8.2(5) release of the ASA also.
http://www.cisco.com/c/en/us/td/docs/security/asdm/7_6/release/notes/rn76.html
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide