Bandwidth Limitation 100M Burstable 200M WAN Link using ISR4431

[johnbloods]

Hi Guys,

I need your help on how to limit the bandwidth from 200Mbps to 100Mbps burstable to 200Mbps facing end customers interface? Is there any command on how to set this up? I tried the Class-Map with Policy map but when I'm in the pmap-c "police" command is not searchable. 

[Mohammed al Baqari]

Hi,

Yes you can use two rate policer with cir and pir. Here you go.

https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/qos_plcshp/configuration/xe-3s/qos-plcshp-xe-3s-book/qos-plcshp-two-rate-plcr.html

***** please remember to rate useful posts

[johnbloods]

Hi, Thanks for the input. I will surely check it out and see how it goes with my config. 

[balaji.bandi]

Good Blog - which explain more details and understanding : ( we can give simple syntax, but we prefer you to understand so you can easily deploy and understand the working nature of commands)

http://brbccie.blogspot.com/2012/12/a-different-perspective-on-cir-pir-tc_1785.html

[johnbloods]

Hi, I will surely read the article and test it out. Thanks