Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

I am trying to setup patterns in Logstash(ELK stack) to monitor FirePower logs.  I am trying to find a documentation that shows all the syslog messages that FirePower can produce to create a pattern file for them.  What I am looking for is similar to...

tsiemers1 by Spotlight
  • 3922 Views
  • 3 replies
  • 0 Helpful votes

We are getting this warning several times a day and sometimes the duration is several hours untill it is cleared from healt monitor. We are running virtual FMC and purly ASA-X with FirePOWER. FMC at latest and greates 6.0.1.1 and ASA's @ 5.4.0.6, a c...

Hi, We have a customer that bought an asa5525-x with firepower, now this is the first time i need to setup an asa with firepower and i run into a small issue. ASA is up and running, Firepower managment Server is up and running and connection betwee...

jpdeboer1 by Level 1
  • 597 Views
  • 2 replies
  • 0 Helpful votes

Is there a work around for firepower vmotion. I vmotioned my firepower VM and network traffic stop. I had to migrate the VM back to the initial physcial host for traffic to flow. My concern is: 1. What if the physical server the VM resides on stoppe...

Hi All,I have tried the wccp http redirection on firewall with squid server and it runs ok then i have tried the wccp https redirection on firewall, its not working. the request goes straight through the firewall. Is the wccp supports https redirecti...

mrbzumrbzu by Level 1
  • 30196 Views
  • 25 replies
  • 0 Helpful votes

I know the SFR module was working because I originally set it up a year ago.  Module is fine on the Primary ASA. SFR module was working fine on the secondary of the HA pair but noticed this: Cisco Adaptive Security Appliance Software Version 9.6(2) D...

collinsjl by Level 1
  • 1681 Views
  • 5 replies
  • 0 Helpful votes

Hi friends. I'm sorry if this is basic, but the Pix world is something I'm not very confident with.The attached configuration is of a Cisco Pix that was used at a remote office. It contains: Inside traffic 172.16.0.0 Inside Nats to: 10.54.14.0 VPN tu...

I have ported over configuration from a Production ASA5520 that has anyconnect, hair pin vpn, split tunnel & a ton of NAT.  I have ported over this configuration to an 5545-X and I am doing the cut over to this new 5545-X in a couple days. I have acc...

When issuing a sh service-policy sfr to view the packet input and output stats I have 0 counter on "Input". I am collecting events in the FMC but I am also seeing this error. Any ideas??? I am running in Monitor-Only" Critical Modules:1,Normal Module...

Unanswered Topics
Review Cisco Networking for a $25 gift card