Network Security

Currently, when adding a Cisco Mobility Services Engine to Cisco Prime, a default trap destination is created in the MSE.The protocol used is SNMPv2. SNMPv3 is also available for additional trap destinations. Is it also possible to change the default...

Hi all, does anyone know how to crate a list of all firewalls with their interfaces and the IP addresses?Example:Firewall XXXX Inetrface XXXX 1 IP XXX                          interface YYYYY 2 IP YYYYFirewall AAAA interface AAAA IP AAAAA            ...

We have a new ASA 5516X and I realize the NAT commands are different on version 9.4(1) and version 8.2 which is our old ASA 5510.  I am unable to create the commands for the following: global (outside) 2 X.X.X.X (public IP address)nat (inside) 0 acce...

Right now I am doing O&M for a small-scale data center which have multiple vrf instances combining with ASA multiple context firewall. I have found that it is quite common to route multiple firewalls through a security device to enforce a security bo...

Please, do the AMP to network (Firepower Services) scan in real time, any documentation? regardsMM

Got a new Cisco ASA 5512-X Firepower and a Cradlepoint MBR-1400 with LTE Verizon and Static IP Address.I set the Cradlepoint to IP-Passthrough and the DHCP is enabled.  I followed the Standard Config on Cisco Site to setup the appliance. Gig0/1 insid...

Hi all I would like some help in configuring interfaces on a 7200. Ideally is there anyway you can configure any interface to auto shutdown if a bandwidth limit has been reached? As far as I am aware I can configure the following command to drop pack...

Hello, We are having some space constraints on the syslog server. After analysing the logs it is found that more logs are being generated by an ASA which sits infront of a DNS server. Hence, the more the DNS query arrives the more the syslog messages...