Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hello, everyoneI have been trying static nat on a ASA 5510 8.2(2), but it is not translating.  Public IP: 1.2.3.4Private IP: 192.168.11.18 static (inside,outside) 1.2.3.4 192.168.11.18access-list outside_access_in extended permit ip any any sh xlate ...

090002aaa by Community Member
  • 6095 Views
  • 12 replies
  • 0 Helpful votes

hey guysi have a server which accepts traffic on one port inside my network and clients outsides needs to access this server. the nat and accesslist works fine but there is a timeout issue and the connection fails ... note that without the asa client...

macazarpros by Community Member
  • 1130 Views
  • 5 replies
  • 0 Helpful votes

HI we had an issue in cisco ASA 5520, when we try to boot the system and press the escape key it is saying "booting system please wait" and nothing comes after that and the system is not booting after that. The Rommon mode is not coming as well, when...

Brief background.  I took a position with a new company and am trying to clean up the network(HUGE TASK). Initially I'm locking down the equipment, and my question is on ASA/PIX firewalls regarding SNMP community strings. I set the RO community, ques...

I'm newer to ASA's and I have the following scenario:External users need RDP access to an internal server, so they need to hit a public-facing IP that gets translated to a private, but I also need to NAT the external users public IP, so that I can en...

susan.lopez by Community Member
  • 1791 Views
  • 5 replies
  • 0 Helpful votes

Resolved! Transparent Mode

Rather unconventional design that i am trying to test with transparent mode firewall.... attached diagram Clients [VLAN 100] connected on L3 Switch with SVI as default gatewayFirewall using one physical port which is sub-interfaced with INSIDE-100 an...

amar_5664 by Level 3
  • 8126 Views
  • 37 replies
  • 0 Helpful votes

Hi,Two days ago I had a problem with secondary unit in the ASA HA. The problem is because of the CX module failed in the secondary unit (service module failed) showing the standby unit failed in the "show fail" output. Just I reloaded CX module in th...

S.ashok S by Level 3
  • 1090 Views
  • 6 replies
  • 0 Helpful votes