Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Friends,I have a Cisco 6509 switch running Version 12.2(33)SXI7 configured aaa new-model.I have 2 tacacs+ servers configured for authentication.When I test the authentication using the "test aaa" command it works fine and the authentication res...
Currently, we are monitoring ASA uptime using SNMP OID 1.3.6.1.2.1.1.3.0 (systemuptime) and we get a reboot alert after uptime crosses 1 year 132 days +. though the device doesn't reboot in actuality. It appears that this OID is a 32-bit counter whic...
I have an ASA where the Ciphers support is limited to 256 bit ciphers only. Why is it not showing 384 bit ciphers?Thanks in advance!-----------------ASA# show ssl ciphers all
These are the ciphers for the given cipher level; not all ciphers
are suppo...
I am trying to block IKE traffic incoming to the ASA using ACL applied on control-plane but it doesn't seem to block those requests.Below is my config:object-group network IPSEC_TUNNEL_IP
network-object host 1.2.3.4
network-object host 2.3.4.5
acc...
Hello Everyone,With the introduction of Global ACL in 8.3 ASA, its like Checkpoint FW now to configure rules.I have a doubt regarding this.Is there any disadvantage if i use only global acl in ASA? Functionally it should work fine but not sure about ...
It appears this OID snmpEngineTime tracks the uptime of the failover cluster and not the individual device. Is there any way to track the uptime or reboot event of a device?
