Network Security

Engage with peers and experts on network security topics such as FTD, FMC, FDM, CDO and ASA.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hello, is it possible to configure an IOS Firewall IPS on a Catalyst 3560? Which IOS version would I need if it were possible? Thanks in advance. Regards---Posted by WebUser José Manuel Garrido Malagón

I have a ASA 5510, the inside addresses go to a 3750 as a channel group two interfaces on the asa are used. The channel group is setup  as a trunk. I can ping the address from the  direct connected switch connected switch however from another switch ...

miket by Level 5
  • 5714 Views
  • 8 replies
  • 0 Helpful votes

Hi Everyone.I have ASA  connected to Switch.This is outside connection.I was trying to Telnet to ASA  from Switch which has outside connection to ASA.I config the commandtelnet 192.168.0.0 255.255.0.0 outsideStill from Switch i am unable to telnet to...

mahesh18 by Level 6
  • 598 Views
  • 5 replies
  • 0 Helpful votes

Having a strange issue with RDP to an XP machine through a L2L tunnel.Tunnel is between an ASA5505 and ASA5510. Site A 5510, Site B 5505I have a handful of Win7 and XP Dev machines running on ESXi 4.1 within Site A.Site B to Site AI can RDP to all Se...

Cybervex3 by Level 1
  • 597 Views
  • 4 replies
  • 0 Helpful votes

We have seen ( though very intermittently , once in 3-4 months) that interface utilization on the switches in DMZ touches almost 100%. Here is our rough topology:Netflow collector----firewall---DMZ---edge router(10.1.1.1)               fw1           ...

Review Cisco Networking for a $25 gift card