Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Newie here.  Changed ISP so new external IP.  Changed the IP address in the config and route, but now have 2 routes.  One to the old IP and one to the new. How do i remove the old route?  Thanks in advanced.

simetraIPC by Community Member
  • 970 Views
  • 3 replies
  • 0 Helpful votes

Is there a way to forward a single port, while leaving the others alone?  For instance I want to forward all https traffic on a public IP to an internal server on port 4443. At the same time traffic on all other ports for this IP needs to be forwarde...

greggeesaman by Community Member
  • 2361 Views
  • 5 replies
  • 0 Helpful votes

Resolved! firewall prompt

Hi All,A ftp server behind asa gives a strange problem. When a user logs in initially, credential prompt appears on the  page. However if that session is closed and a new session is opened for the same user, using browser or command line, they are di...

suthomas1 by Level 7
  • 616 Views
  • 1 replies
  • 0 Helpful votes

I am looking over a config of an old ASA5520.  One network has this ACL applied:access-list acl_dmztest extended permit icmp any anyaccess-list acl_dmztest extended permit ip any anyaccess-list acl_dmztest extended permit tcp host 10.10.10.10 host 10...

I brought Firewall ASA5505 “ASA5505-50-BUN-K9 “(is there possible to upgrade same device to “ASA5505-SEC-BUN-K9 “if yes then how)I am new for FirewallNow I tried through Cisco help / YouTube / Google etc. i got internet after few changes also pinging...

it4mazars by Community Member
  • 663 Views
  • 1 replies
  • 0 Helpful votes

HiOtherday we had a problem with my FWSM. There were huge no of xlate connections shown in the firewall. Traffic was not going through, interfaces were in hung state, had to reboot the FWSM beside blocking the IP Addresses from where the huge number ...

Hi,I am getting the below  messages in my cisco asa 5520, during this time tunnel is down. just what to check whether the problem is at remote FW or with asa. local fw: asaremote fw : check point UTM edgejan 12 2012 10:50:27: %%asa-3-713902: group = ...

Top Solution Authors
Review Cisco Networking for a $25 gift card