Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys, As i can see, Cisco is recommending for the ASAs to be in transparent mode in data centers, my question, why not routed mode?How to decide? what is the problem in having the routing on ASA?I know that transparent mode is easier to place, but...
Hi Guys,ACS 5.5 is installed on SNS-3415 appliance.Integration with Active Directory 2012 has been successfully completed.The problem which I'm facing that i can't see all the groups of AD under ACS, i see only few of them.Also if i created new Group...
Hi guys,I'm connecting an ASAs as Active/standby failover to nexus 7000.Please find the attached network diagram to understand the setup.- No direct cable between the two ASAs.- Failover link is done by connecting g0/3 to N7k1 and N7K2 (as the diagra...
Hi guys, Suddenly, one of the modules under 7K switch gave red alarm. Following are the show module:#show moduleMod Ports Module-Type Model Status--- ----- ----------------------------------- -----------------...
Hi Marvin,
Thanks for your reply.
In my setup, I will order ISE-PLS and ISE-APX, do still I need Anyconnect Plus/Apex?
And as I know, Anyconnect can't be installed on ISE, it should be installed on ASA.... where the Anyconnect license will be install...
Hi Marvin,Thanks for your reply.- If i have an issue with spanning tree, why do you think it is working fine over vPV peer link?- Both switches are active because we configured peer switch under vPC, and in this case both spanning tree priority shoul...
