Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

I have typical ASA 8.2 NAT configuration along these lines:global (outside) 1 3.3.3.3nat (inside) 1 0.0.0.0 0.0.0.0static (inside,outside) tcp 3.3.3.3 www 10.1.1.1 www netmask 255.255.255.255...but I also need the "outside" users' source addresses to...

Hi experts,I'm testing the new 8.3(2) firmware on my lab 5510 ASA. I'm trying to block certain URL (facebook in my lab). It works fine when I just have one "match" clause. As soon as I have the second it starts to tear down all the http connection an...

/* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-priority:99; mso-style-qformat:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in ...

amhughes1 by • Visitor
  • 1064 Views
  • 2 replies
  • 0 Helpful votes

I am having an issue with an ASA 5510 device and web load balancers.Currently in places is a sonic wall which needs to be replaced with an ASA 5510.The sonic wall works just fine with the load balancers.If we put the ASA in place with the same config...

Mr_Izerian by • Community Member
  • 769 Views
  • 1 replies
  • 0 Helpful votes

HI,I have Windows 2003, Solaris, HP-UX, and Windows 2008 servers that have non-default window sizes setup to help increase file transfer times.  These servers are behind an ASA and copy to mirror servers behind another ASA.  When I run a cap on these...

i have a problem with my pix 525.it starts to boot and then hangs at that spot forever.m  not sure if its an ios issue or notCISCO SYSTEMS PIX FIREWALLEmbedded BIOS Version 4.3.207 01/02/02 16:12:22.73Compiled by morlee256 MB RAMPCI Device Table.Bus ...

daemibros by • Frequent Visitor
  • 1578 Views
  • 2 replies
  • 0 Helpful votes

Hello I'm configuring 2 ASA for failover. The first configuration of the primary unit is done ! For the second unit,  do we have to configure the ip address of the interfaces and the other configuration or just Failover command  ?Do we have to do 'no...

eoudrhiri by • Community Member
  • 965 Views
  • 2 replies
  • 0 Helpful votes