Network Security

/* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-priority:99; mso-style-qformat:yes; mso-style-parent:""; mso-padding-alt:0in 5...

I have faced an issue today in which one of my clients wasnt able to reach the Internal Servers hosted on the DMZ at my side, following were the logs which were captured on the firewall . Keeping in mind we have more than 100 customers and no one was...

Hello,I'm not even sure if this is possible, but is it possible to get our SharePoint site publicly available over the internet through a portal page, I think my ASA 5520 can do it, but not sure of the license etc.  We want the user to get to a porta...

I am having an issue with an ASA 5510 device and web load balancers.Currently in places is a sonic wall which needs to be replaced with an ASA 5510.The sonic wall works just fine with the load balancers.If we put the ASA in place with the same config...

Hello,We currently have an ASA running 7.2(2).  We have NAT rules setup to change XXX.XXX.93.106 to 10.70.8.31 on port 636 for external LDAP connection.  This rule is working without a problem for two of our external websites.We are trying to connect...

Guys,I want to divert the traffic originating from E3(Server Farm) to E2 using some kind of route-map/PBR but found out that ASA doesnt support this. Is there any other way to accomplish this? Thanks,Chad

Hi all!I've an ASA 5520 having one interface (GUEST) with security level 5.Now, if i add a rule to permit all traffic to outside network (like permit any any), i see that they can also reach the INSIDE interface (security level 100).I have to deny th...

Hello I'm configuring 2 ASA for failover. The first configuration of the primary unit is done ! For the second unit,  do we have to configure the ip address of the interfaces and the other configuration or just Failover command  ?Do we have to do 'no...

Hello,I just created a new and simple  signature. signature 60002 for failed telnet. My setup is Promiscous mode . signature 60002engine string-tcpservice-ports 23direction from-serviceregex-string % Bad passwordsalert-frequency fire-allDid I miss so...

Hello All,We have ASA5510 as a NAT server, and it works correctly on NAT for inside computers.But for some concern, we want these inside hosts connecting to some outside network hosts with a different route.i.e.:inside_hosts  --------->  Internet    ...