Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Running 15.0(1)M4 in a 2901. I'm migrating a 2800 config which has the following voice port config:connection plar opx 8400.This syntax doesn't work in version 15. The options are "connection plar tied 8400" or simply "connection plar 8400"> Is the...
I have ACS 5.2 running as a VM. I'm AD, then local authentication successfully for device access, but I want to define ACS user groups to restrict login. I don;t see any way to do this. If I use AD groups, they don;t show up as selection options on...
My customer is tight on SN space, so they set up 400GB for the ACS AM. I saw a message about having less than 500GB flash by during the DVD install, but it seemed OK otherwise. When the VM boots off the HD, I get the localhost login prompt, and I t...
Customer is running multiple 3750x stacks, 5 or 6 switches per stack, power stacks of 2 or 3 switches per stack, 2 PS per switch. All 12.2(53)SE2 ipbase. All powers supplies OK, cabling correct per stack-power output, and confirmed visually. One p...
My customer has ASA 8.2, and is setting up a webvpn portal. He would like to allow some users to use AnyConnect, but others would onky e allowed clientless access. He is using NT authentication. I have set up two different group policies, which do...
Aner,I'm entering it under the voice port. Connection plar itself works fine, but I can't enter "connection plar opx 1234". This was accepted under 2800/12.2 SW
