Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Resolved! ssm-ips on asa

2 asa's with ips module are in place at our centres. one of the modules in them seem to be not present. however both acl's for ips on primary & secondary asa's have hitcnts increasing.these were configured by one of my previous colleagues and i am no...

suthomas1 by Level 6
  • 1463 Views
  • 9 replies
  • 0 Helpful votes

Resolved! asdm

Facing trouble with using asdm on asa version 8.0(4)  asdm version is 6.1(3)Java installs have been tried , but the asdm launcher hangs off for indefinite time after credentials are keyed.we have tried to load it with IE option also.it has to be manu...

suthomas1 by Level 6
  • 7373 Views
  • 17 replies
  • 0 Helpful votes

Hello All,I am having Cisco ASA 5505 firewall. i am having 2 ISP connections. I wanna connect both links to firewall.Is it possible to do failover & Load Balancing Using ASA 5505 ??If it is possible then How to do that ?Please guide me ....Thanks.

vinayak by Level 1
  • 2237 Views
  • 4 replies
  • 0 Helpful votes

Here's the situation, my network has a Cisco 1811 router. This network is going to be mostly used for remote field operators to VPN into the system (via SSL vpn) and once they have established a VPN cnnection they will use a remote desktop protocol (...

jsandau by Level 1
  • 1434 Views
  • 5 replies
  • 0 Helpful votes

I am trying to setup LAN based failover Active/standby between two 5550s.  As I was reading a documentation on Cisco website, it is instructed that all of the interfaces are needed to be configured with active and standby ip addresses.  I'm trying to...

Peter Kim by Level 1
  • 2830 Views
  • 4 replies
  • 0 Helpful votes

I read in the book "Cisco NAC Appliance: Enforcing Host Security with Clean Access" (published 2008) that the Real IP Gateway mode is only IPv4 compatible but that IPv6 compatibility will be provided in a future software update.Having searched around...

We have some old systems that use nat-control as they were upgraded from older pix releases.My main question is, if we disable nat-control, what other actions are required?For example, does the firewall needs to be restarted? or Clear all xlate and c...

pavlosd by Level 2
  • 3398 Views
  • 2 replies
  • 0 Helpful votes

Hi,Below is my configuration detail which from which I have been having difficulty access the DMZ (webserver)from the outside.thanksasdm image disk0:/asdm-508.binasdm location 192.168.1.5 255.255.255.255 DMZasdm location 192.168.0.0 255.255.255.255 I...

I'm being asked to send logs from an ASA5510 to a syslog server on port 40991 thats behind an interface with a security level of 50.At this point it's not working, the syslog server is 192.168.233.43 and it's behind an interface named APP with a secu...

w951duu by Level 1
  • 1060 Views
  • 4 replies
  • 0 Helpful votes