Network Security

Good morning,We're looking at implementing inline interface pair mode on our IDSM-2.  Does that automatically pass ALL vlan traffic through the IDSM-2 or would we still need to define which VLANs will go through it?Ron

Hi all,I am currently in the process of putting together an LLD for quite a large campus L2 OOB Virtual Gateway NAC deployment.I wanted to check something simple at this early stage which is not clear from the docs I have read so far. Can you only ha...

I have more than fifteen CAS’s in different geographical location (state) and controlled by CAM HA that is located in another location (state). I’m currently running NAC version 4.5 and planning to upgrade to 4.7.1. due to Windows 7 compatibility pro...

Hi Friends,I am facing problems in our NAC implementation. AV popup is not whowing. Also the rules could not be downloaded. A screenshot is provided.Please suggestregards,Rajiv

we currently have a Microsoft ISA server separating our internal network from the outside. The outside NIC has a secondary ip assigned to it, so for example purposes, lets say the outside interface primary is 1.1.1.1 and the secondary is 5.5.5.5. The...

Hi,I have to access an outside server connected through a third party VPN tunnel at DMZ Interface on my ASA 5520. At the same time, outside secure server should be able to access two servers on my inside network as well. I have configured the CISCO A...

Dear ALL,I have a Cisco ASA 5510 as firewall which is directly connected to a Cisco 2600 series router (this is supplied by ISP) .ASA's outside is connected to router's interface by a patch cable.Every thing seems to run properly but I experienced to...

I have IDS 4250 running 5.0 software. I mange it through IPSMC . I am getting lots of false positive on my IPSMC security monitor console. How do i filter it so it does not shows up in security monitor. In IDS 4.X version there was an option in IDSMC...

I am not sure if this is possible, and if it is, I am then not sure how this would be accomplished:We will have 3 separate WAN connections provided by 3 separate ISP's coming into our office.  How may I set it up so that all three are firewalled usin...

I have spent the last few days trying to get my VoIP box exposed to the internet using a static public IP and port forwarding.  However, most of the posts I have read thus far only deal with forwarding one or two ports, usually a single IP on the out...

Wondering if anyone else has had this issue.Situation is that units are trading active status between devices.  Was fine until about a week ago. Performance has been sluggish and asdm is slow to load, sometimes dropping connection.  We have multiple ...

I have an urgent configuration issue. I have port 80 open and forwarded through my firewall which works great from the outside but does not work from within the network.Have tried the same-security-traffic permit intra-interface command and everythin...

Hi All,I have two Routers running HSRP on the inside interfaces (LAN interfaces) tracking the outside interfaces (ISP interfaces). I have both routers handling both connections (two ISPs)So, basically the configuration is as follows (for the primary ...