Network Security

I'm using a VPN concentrator and running into some trouble. I would like to be able to assign a different DHCP pool to each group. They can be within the same /24, if necessary, but I need to be able to control which smaller group they are put into. ...

I have a Clean Access 4.1.8 RealIP Gateway deployment. I recently went through a domain name change and applied new SSL certificates and now I am having severe communication issues.When I click the manage button for the CAS I often get an error: "Cou...

Is anyone running the 7.x code on the Cisco IPS yet? Any problems? Turn on the global correlation yet? ScottS.

I have two ASA 5540s that I would like to configure for VPN load balancing. I had been looking at the Active / Standby configurations, but am curious if doing this I can truly get VPN load balancing or if this means all VPNs on the active unit and th...

Hi,I have a cisco PIX 501 in which remote VPN is configured for our company. Currently, for the remote users, the authentication is just a vpn groupname and a password. All the users use the same credentials for logging in. Can I have separate remote...

Hey Guys,Is there a way for Cisco client based users to use static addresses instead of receivinga a dhcp address? This will be setup on a Cisco 2801 router. We usually just do dhcp but this customer is requesting static address for each user.Thanks ...

Hi all i am trying to figure out the load-balancing between 2 idsm2 modules in the same chassis. this is the config i am trying to dorouter(config)# intrusion-detection module 6 data-port 1 port-channel 5 (idsm1)router(config)# intrusion-detection mo...

We have a client with a Cisco 871 router and we want to setup users with the ability to use the Cisco VPN client software and conenct to the office 871 router to gain access to resources behind the 871.Could someone please give me a few tips or steap...

Hello,I have 30 locations hub and spoke off from an mpls network. There is also a DSL vpn backup to each location. Both MPLS and VPN terminate into a 2811 onsite at the remote branches. We are using IPsec VPN Tunnels. We are using eigrp as a routing ...

Have I missed the obvious? I want to record the configuration of my CAM/CAS in a human-readable format. All I can think of is screen shots, but these don't show the full character string in a scrolling text box, and also after 40 screen shots I still...

Dear All,I would like to ask you some question that i have the problem, so i cannot sovle.i was configure VPN client on ASA. and the VPN client now it is working and and can ping to LAN HQ.and my problem can not ping 40.40.40.1 other lan.Pleaes kindl...

HelloI have tunnel s2s via ipsec. On my asa i have inside and outside interface. My LAN are 192.168.10.x, Remote LAN 192.168.20.x I try to debug problems with connection which comes, initialized from remote site to my ASA. When ipsec packet arrives t...

Hello, I have NAC configured to run some Nessus scans but I keep coming up with this for any application-specific ones... Please advise on what I'm missing. I don't know what this means.[Thu May 21 14:25:30 2009][7152] user perfigo : Not launching qu...