About BrinksArgentina

BrinksArgentina · 05-26-2009

Why date/time of the posts are in PST timezone and not in local tz? This little improvement can help to distinguish between a recent post and a post with a few hours on the table.Thanks.Guido

BrinksArgentina · 01-10-2008

I issue a clear configure all, setup the interfaces and with this minimal configuration, a PC conected to the DMZ interface, can contact the router on the outside.The ASA routes ip and (this is a lab) cause the router has the ASA as defaut gateway, t...

BrinksArgentina · 01-06-2012

Hi friends,I'm planning a network for a new building and have to take de decision for the core. I will be very happy if I can unify LAN and SAN. But can I do that with a reasonable cost?I'm ok with 160G routing speed.should I buy two 4506 (plus 5548 ...

BrinksArgentina · 04-07-2010

Hi Jean,Do you see this error logged on the firewall:%ASA-6-302014: Teardown TCP connection...Flow closed by inspectionIf you see this error, you may try disabling sqlnet inspection.Guido.

BrinksArgentina · 01-12-2010

The max distances may be short if you use an UTP cable as E1 crossover, but the max distance is 600m for unbalanced BNC cable.Crossover:http://wiki.sangoma.com/Cablepinouts#t1_e1_cross"The VWIC-MFT-E1 receiver operates in a short haul mode and can re...

BrinksArgentina · 08-09-2009

Do you have tested the previously posted commands?(replace 200.1.1.x with you public address)global (outside) 1 200.1.1.2global (outside) 2 200.1.1.3nat (NOC) 1 192.168.12.0 255.255.255.0 nat (QA) 2 192.168.14.0 255.255.255.0 access-list traffic_wwwN...

BrinksArgentina · 08-07-2009

How many public IP addresses do you have?You need a /28 at least. One public IP for each global nat pool.Guido

Member Since	‎11-18-2009 08:37 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	66
Total Helpful Votes Received	32

User Statistics

User Activity

Timezone

My ASA 5520 route without setting up an exepmtion nat

Re: Nexus 5548 and Routing

Re: SQLNet Inspection

Re: G703 Multiflex

Re: Setup Bandwidth Limit on V-Lans

Re: Setup Bandwidth Limit on V-Lans