Network Security

I have a system that we NAT through a firewall. A partner whom we are setting up a VPN connection with only will accept registered IP addresses. The way our network is setup, I will have to NAT this address again to a public IP. So I am wondering wha...

I am getting the following error on ASA which has AIP-SSM module when pinging out through ASA (AIP-SSM)%ASA-4-420002: IPS requested to drop ICMP packet from 'source' to 'destination What can be done to make the ping work.

Hello there, I've recently connected a Cisco 871 router to a ISA 2004 server (site to site VPN). The connection details are listed in this Microsoft article: http://technet.microsoft.com/en-us/libr ... 02442.aspx The tunnel works, but it tends to dis...

Has anybody implemented NAC guest server in conjunction with SMS tokens.Is there some docs. on how to?

Dear Experts,I Have ASA 5510 and I have a limited number of Real IPs, I need to get 3 of my users an access to a service whose their providers asked me for their real IPs to add them to their Access List.Actually I want to use PATing instead of NATin...

Hi The users from the inside zone lan placed behind ASA are not able to access the videos .The user LAN is Hide NATTED behind the Outside interface of ASA in order to access the Internet traffic.Hence please guide as to what could be the probable cau...

Hi, the following error message apears in the secondary FWSM unit:Config Sync Error: Following command could not be executed on standby access-list privilegeados commit-status committed line 83 extended permit ip host 172.26.55.67 any time-range VERA...

Customer secondary pix failed. Replaced secondary pix. Using serial failover. units replicated secondary pix has config actually failed over to secondary and worked. 5 days later configuration on secondary is gone. Did not reboot either pix.

Hi,I am trying to receive a multicast tv stream from outside our network through a Cisco ASA 8.0.4 firewall and into our internal Network. I have a router outside the firewall which is picking up the stream and if I plug into the switch that the rout...

I have two firewall configured in fail over, in production, i need to change ip segment of ip state. ----------------------------------------------------Model: PIX-515EVersion: pix7.2(4)--------------------------------------Conf:interface Ethernet5 d...

When configuring ASA's in A/S should you be able to connect to the ASA in standby mode?

Hi All, we have two ASA 5510 connected through MPLS network, and there is other route with T1 to the internet. I'd like to configure VPN tunnel as backup. If MPLS get down, I want ASAs initiate VPN connection with each other and create a tunnel. If y...

Hi,I have a Cisco ASA 5510 and need to use it to route between VLANs as i don't have a router for the time being. I have been reading online and it is possible as it is a layer 3 device, although I can't seem to get it working.I have an inside, outsi...