Network Security

Hi,I have a pair of Pix's configured for failover and stateful sync, but i have discovered that the sync is not working, after some investigation it looks like one of the FW's has had its interface assigned to the wrong VLAN.So the fix is to assign t...

Hi, I have home ezvpn clients (851s) terminated on a headquarter ASA5520, those home workers may call each other at home with Cisco VoIP phone behind 851s, call managers are in HQ, those VoIP phones have corp extensions. Often times users complain vo...

We have a Pix 515 fw with an inside and outside interface that has the following static NAT:static (inside,outside) 10.2.2.2 192.168.2.2 netmask 255.255.255.255We also have a NAT acl that looks like:nat (inside) 1 access-list outbound-natglobal (outs...

Hi,I'm trying to provide suggestions regarding Cisco IPS Active Update Bulletin contents. According to a banner I can send my suggestions to "As always, please feel free to e-mail us if you have any comments or questions ([email protected])"I tried ...

I am in need to restore the configs to a new asa but they are running different ios software. How can i acomplish this?

When I try to log into Clean Access to use the internet, it gives me an error message saying that in order to fulfill all of my requirements and get into the system, I need to download windows defender. But Windows defender comes with Windows Vista, ...

Hi, We have two sites which are connected via IP Sec VPN STS Tunnel and yesterday it was working fine. Today we are experencing few issues like when we connect with Remote Server through RDC then after some time the session gets disconnected and same...

I have an ASA model 5510 on my client site. I want to use the Management interface to manage the ASDM and SSH connectivity to the box. I have configured the appopriate IP on the management interface and enabled it.For whatever reason, I am unable to ...

I am looking for some recommendations on how to implement two-factor authentication on SSL VPN and Cisco AnyConnect VPN connections.Curious what others are doing or what options I have.Thank you

Hi,I need your advice. tried to enable Firewall on the ISR using zone security but whenever i apply it on the interface (in/out)some of the ports like 3389 etc are blocked. Need to know if there is anything i need to configure to accept port 3389. cl...

I am trying to find the uptime of a vpn tunnel of a PIX 501 version 6.3.Does anyone know if there is a way to do this I would like to know how many days and hours the session has been running for.Thanks in advance for any help on this.

How would I go about installing and printing to a printer that is shared on a computer (WinXP) that is on the outside interface of my ASA5505?

Hello there! I have a ASA5540. I am facing a problem with it accepting the enable(exec) mode password. All the other devices are accepting the password except ASA. I do have configured the ASA with following commands for ACS:aaa-server abc protocol t...

Good Afternoon:Someone know if i can get reports from the Cisco Security Manager, as mayor port's used, mayor rules used, mayor denys, an graphics?If not is posible wich software can do it?