Network Security

I have URL logging enabled on my ASA-5505, with a default HTTP fixup policy. URL log messages go to my syslog in this format:2008-01-31T16:49:52-0600 <local4.notice> x.x.x.x %ASA-5-304001: y.y.y.y Accessed URL z.z.z.z:/index.htmlThis is exactly what ...

We're having some problems getting our VPN service fully functional. We've managed to create a easy vpn server through the SDM interface and that part is fully functional.We can connect from the outside to the router and we are getting the correct Ip...

Hi All,we recently upgraded from 6.3 to 7.2.2 and had an issue with the size of the file.The file itself was 184k and contained approximately 4000 lines. The release notes specify the file can be 1mb. Does anyone know how the system calculates the si...

Does anyone know why Sec Mon will not populate any new alarms? Audit log shows: Alert Inserter Error (Insert Thread) - setStrValue: too many chars for target | Alert Inserter disconnecting from database and exitingHow do I correct this problem? Versi...

Hi,Does anyone have an idea on this .Which version of pix IOS supports H323 with AES enabled for polycom devices ?Raj

Hi. The CSA (v4.5) log file is displaying this message:'The event database now contains approximately 18000001 events. This is in danger of exceeding the configured limit. In order to preserve correct operation, events of priority Alert and below wil...

Hi hi,Wonder if anyone can help to provide some information on how the followings can be done. thanks a lot in advance.Current Infrastructure is as below.ISP <--> 3825 Router <--> ASA 5510 <--> Private network and DMZHad configured a IPSEC/GRE tunnel...

Hi,Which studies should I take to configure this blade?642-552 SND and 642-523 SNPA?Thx,Marc

I have an ASA5520 that as a problem.It's like this… it drop packet in the outside interface and in the inside interface.The inside interface of the firewall is connected to a switch that is not Cisco, and the outside interface is connected to a rou...

I have two identical 5550 units with the same features and licenses, I want to implement failover between them, these are brand new and I am going to use them for the first time, I need some guidelines, I have the scenario as following I have one Ser...

HiI have a lan to lan VPN setup with 2 cisco pix 515e. One of the firewalls is in the uk and the other is in France. I can intiate the tunnel from France by pinging an IP address in the UK. If I ping France from the UK the tunnel fails at phase 2. An...

Hello, everyone. I have a PIX VPN/firewall that works great for providing VPN access from behind other NAT'd firewalls (Apple AirPort, Cisco PIX), but when I try to VPN from behind a Linksys WRT54G (firmware 8.0.0.2), I can authenticate the IPSec con...

is there a way to set the pix to do automatic backups of the configuration to a TFTP server!

Hi I have two pix 502 firewalls with an IPSEC L2L tunnel between them. The L2L tunnel establishes and is working fine. I added the dynamic VPN for road warriors to connect in but I get the following errorIPSEC(validate_transform_proposal): invalid lo...