Network Security

Hello,How can I get the PIX log to show a timestamp that shows the time and date.I get a strange #. Below is my show clock and show log output.thanks,rrc> PIX(config)# sh logg> Syslog logging: enabled> Facility: 20> Timestamp logging: enabled> Standb...

I would like to know if SNMP packages are available in order to monitor IPVPN/MPLS base connection? What MIBS do I need to load into my SNMP central agent?

I have a PIX 515E (2 interfaces) and I need to route SSH (port 22) traffic inbound to an internal host.Even though I have entered the command to allow SSH in the access list the PIX still blocks the traffic. All other services work fine (port 80,25)....

can I open telnet session with PIX from outside ??and how can this be doneso i can telnet to the PIX from any IP ?and if this can be done can i add any security so to compensate for openning such a hole in my firewall

Dear All,We have the following scenario:DHCP Server --- PIX515 ---- Internet ---- VPN Client1. VPN Client terminates the tunnel to the PIX.2. PIX assign an internal IP address to the client.3. The pool IP address is received from internal DHCP server...

I have cisco pix firewall which i have configured for both site to site and site to clinet. Clients are able to connect using vpn client but when i have a site to site with customer's firewall(Symantec) and when i try to ping his internal ip address ...

hi,I have CiscoWorks 2000 LMI1 , with CiscoView 5.3In my 7206 VXR router there is two Escon Channel [ PA-4C-E] , in the default packages of the CiscoWorks 2000 LMI, this card is not supported , so I downloaded the Rtr7000.cv50.v13-0.zip ....the probl...

I am trying to create a VPN between a Cisco 1721 and 827 (ios 12.2(8))and have tried Setting the 1721 up as a Easy VPN Server and the 827 in both Client and Network-Extension mode and the Client gets the DHCP pool from the server but there is no traf...

I installed a VPN Concentrator 3005 at a customer site and set it to tunnel everything. Internet access is provided via a separate PIX. For some reason I can't figure out, Internet access isn't working anymore.The PIX and 3005 are installed parallel ...

I have a market data vendor who continues to insist on using directed broadcast. I need to put their circuit outside a firewall. Can I do something like:static (inside,outside) ftp 65.220.255.255 10.1.255.255 netmask 255.255.255.255 0 0Along with an ...

HI,The outside interface of our PIX firewall responds to pings coming from the Internet. Is there a way to prevent it from responding so a ICMP scan from the Internet won`t find it ? We`re using conduits and we run version 6.2.I`ve searched the doc w...

Do anyone know what is error mean?ip_get_ports: TCP or UDP packet has no port in headerip_get_ports: TCP or UDP packet has no port in headerip_get_ports: TCP or UDP packet has no port in headerip_get_ports: TCP or UDP packet has no port in headerip_g...

Does anyone know if there is software out there that can remotely configure (not monitor) multiple VPN 3005 concentrators?

Does anyone know if you can put a secondary address on either the global or inside interface. What I am trying to do is have telnet access to the PIX but I have only been able to it from the inside. Is there other commands besides the conventional ( ...