05-17-2016 02:26 AM - edited 03-12-2019 12:45 AM
hi all,
i've configured 2x ASA for active/standby and i think i've messed up the config.
was trying to 'force' the standby ASA with the 'no failover active' command on the active ASA.
i'm seeing the 'NoFailover' hostname prompt and 'Failover Off' when i issue the 'show failover' command.
can someone advise how to enable/activate again the failover feature on active ASA on the 'admin' context?
FW01/pri/actNoFailover# sh failover
Failover Off
Last Failover at: 01:12:06 UTC May 17 2016
This context: Disabled
Active time: 0 (sec)
Solved! Go to Solution.
05-17-2016 01:11 PM
Hi
It looks you like you have disabled failover by using the command "no failover", so to enable it just write the command "failover" again.
05-17-2016 08:35 AM
Would you mind posting your failover configs?
Was your active/standby working before? Is your failover enabled?
05-17-2016 01:11 PM
Hi
It looks you like you have disabled failover by using the command "no failover", so to enable it just write the command "failover" again.
05-17-2016 07:46 PM
hi,
looks like i've mistakenly issued a 'no failover' instead of 'no failover active' when i was doing a failover test.
all good now :)
FW01/pri/act# show failover
Failover On
Last Failover at: 04:15:26 UTC May 17 2016
This context: Active
Active time: 51985 (sec)
Interface outside (103.29.5.6): Normal (Monitored)
Interface inside (172.27.24.4): Normal (Monitored)
Peer context: Standby Ready
Active time: 0 (sec)
Interface outside (103.29.5.7): Normal (Monitored)
Interface inside (172.27.24.5): Normal (Monitored)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide